The product is a liquid solvent-free two-component adhesive. It consists of a modified polyamine curing agent and epoxy resin as the main agent

Mainly used in the stone processing industry, used to strengthen the repair of stone surface cracks, small holes, sand holes, ant road, convex and concave inequality, improve its surface quality. Can also be used for glass gauze reinforced fragile slate. The product can also be used for bonding other materials such as hard PVC, steel-iron, steel-steel, ceramics, polyurethane, paper and wood

1. the bonding part of the rough grinding, and remove the stone surface of the oil, dust and other pollutants, in order to keep the surface clean and dry, and slightly rough bonding surface
2. stone surface preheating can speed up the curing speed, can improve the mechanical properties of cured products
3. Proportion (weight ratio) A 4 parts, B 1 part. After weighing, it should be thoroughly mixed until the color of the mixture is consistent. If necessary, add Kodar color paste for color adjustment, up to 5%
4. the mixture can work for 30-50 minutes (25 ℃), with a fine tooth scraper or wool brush. For large area cracks and strong absorption surface should be repeated operation; for small cracks, should be scraped back and forth, so that the glue liquid multiple penetration
5. After about 48 hours at room temperature (25 ℃), the treated surface can be polished and polished. If the slate is preheated to about 60 ℃, then gluing and baking the plate, after 2 hours, the next processcan be entered.
6. Tools can be cleaned with Keda special diluent or cleaning agent
7. Increasing the temperature will accelerate the curing reaction, and lowering the temperature will delay the curing reaction
8. Before handling the empty tank, the packaging tank must be completely emptied.

1. please wear protective gloves during construction
2. The construction surface must be cleaned. When used for bonding, the smooth surface should be polished to avoid affecting the bonding strength
3. glue is now in use, the amount of glue should not be too much, so as not to make the working time is too short, and affect the operation. When weighing component A and component B, different tools shall be used separately and shall not be exchanged. Please cover the lid after use
4. The blended glue has become thick or initial set, please do not use it.
5. Ensure the correct mixing ratio and full mixing to get good mechanical and chemical properties, otherwise, the performance will not be guaranteed, or even lose its effect
6. When the temperature is below 10 ℃, the curing reaction is slow, and the curing temperatureof the place should be used carefully or increased
7. such as glue viscosity is too large can be added absolute ethanol or acetone dilution, or the plate for preheating after use, or the glue placed in 40-80 ℃ water bath heating, to reduce the viscosity, in order to improve the permeabilityof the glue
8. fill layer once hardened will not be dissolved, unless the use of mechanical force or high temperature damage
9. The adhesive overflowing from the bonding part shall be cleaned with a cloth dipped in a small amount of alcohol or acetone before curing.
10. The slate after glue adjustment must be placed flat. After the glue is cured and does not stick to hands, apply a proper amount of lubricant such as talcum powder on the slate, and then stack it to prevent the upper and lower stones from sticking together.
11. If the product is used correctly, the cured product is harmless to the body
12. different stone, processed stone surface will have different degrees of deepening
13. the construction site should be well ventilated, no fireworks, prevent children contact, do not enter