This product is Wuhan Keda Yunshi Care Material Co., Ltd. carefully developed and comprehensive market quality products. It is suitable for fine seam bonding and low temperature construction. It has the advantages of smooth and delicate, easy to reconcile, high transparency of transparent adhesive cured products, hard falling off of stone wire bonding and polishing, no sagging, no oil leakage, etc.

is widely used in building stone, ceramic, vitrified brick rapid positioning and parquet, repair and bonding

1. The surface to be treated should be clean, completely dry and slightly rough
2. Add 2-3 parts of curing agent to 100 parts of colloid 3. Mix the two components fully and evenly, and apply the glue adjusting knife to the surface to be treated

1. do not mix the remaining glue back into the tank
2. Place in a cool place and close the lid after use
3. The glue is not recommended for structural bonding such as stone dry hanging
4. It is not suitable for construction in humid places. If the air humidity is too high, the colloid surface will stick to hands
5. The construction temperature should not be lower than -10 ℃ and higher than 40 ℃
6. bonding parts do not frequent contact with moisture and frost cold
7. This product should be used and fixed within the operable time. Once the initial coagulation is found, please do not continue to use it.
8. The initial setting time of this product is about 3-6 minutes at 25 ℃, which is shortened with the temperature rise and extended with the temperature drop. If the operation time needs to be extended or shortened, the proportion of curing agent can be appropriately reduced or increased. It is recommended to adjust the sample test time before construction.
9. At low temperature, we recommend use our factory's winter curing agent to accelerate the curing process